NerdQaxe++ Hydro – Plebstyle Edition – 4.9 TH/s – incl. Power Supply & Stand

Highlights

• ⚡ 4× BM1370 (S21 gen) – approx. 4.8 TH/s
• T‑Display‑S3 (ESP32) with color LCD
• Water cooling with dual‑side VRM active cooling (copper heatsinks front & back)
• Designed for up to 300 W TDP – ample thermal headroom
• NOCTUA premium radiator fan (NF‑A12x25 PWM) for ultra‑quiet operation
• Front LEDs controllable via remote (separate power supply)
• LEICKE branded PSU – 150 W (12 V / 12.5 A)
• Stand included – as shown
• Pre‑assembled & tested – plug in, connect, mine

Cooling & Acoustics

The custom hydro cooling system dissipates heat via a 120 mm radiator and is rated up to 300 W TDP.

• Dual‑side VRM cooling:
  • Rear: Intake air flows across copper heatsinks to actively cool the VRMs from the back.
  • Front: An additional fan washes over the VRMs from the front – each VRM with its own copper heatsink.
• Thermal headroom: Significantly lower VRM & chip temps under sustained load; improved clock stability and efficiency for 24/7 use.
• Acoustics: The NOCTUA NF‑A12x25 PWM provides high static pressure at low RPM – resulting in an extremely quiet day‑to‑day operation.

Specifications

• ASICs: 4× BM1370
• Hashrate: approx. 4.8 TH/s (depends on firmware & environment)
• Power draw: approx. 80 W
• Controller: ESP32‑S3 with color LCD (T‑Display‑S3)
• Cooling: Water cooling (up to 300 W TDP) with NOCTUA NF‑A12x25 PWM + dual‑side VRM airflow over copper heatsinks
• Power supply: LEICKE 150 W (12 V / 12.5 A, EU)
• Stand: included (as shown)

In the box

• NerdQaxe++ Hydro – Plebstyle Edition
  • NerdQaxe++ pre‑installed, fully wired and tested
  • Pre‑mounted hydro cooling (radiator + front LED)
• Remote control for the front LEDs
• Separate power supply for the LEDs (with EU plug)
• NOCTUA NF‑A12x25 PWM as radiator fan
• LEICKE 150 W PSU (12 V / 12.5 A) for the miner (EU plug)
• Stand (as shown)

Important note

Device performance and efficiency strongly depend on the ASIC clock frequency. Overclocking without adequate cooling can damage the device. No warranty is provided for damage caused by overclocking or by future firmware versions beyond the shipping state. Changes to the clock rate (overclocking) are at your own risk. No liability is assumed for resulting damages.