NerdQaxe++ Copper – 4.9TH/s – incl. 120W PSU & stand

The NerdQaxe++ uses 4 × BM1370 ASIC chips (S21 Pro / Plus series) and achieves a stable performance of 4.9 TH/s in standard operation. Made in Germany.

Highlights:

• ⚡ 4× BM1370 (S21 Pro / Plus) – 4.9 TH/s (standard operation)
• 🧊 Thermalright AXP90-X53 Full Copper – full copper cooler
• 🧠 Open Source Hardware & Firmware
• 🖥️ LilyGo T-Display-S3 with color LCD & integrated ESP32
• 🔌 120 W power supply (12 V / 10 A)
• 🧱 Comes with 3D-printed PLA stand with brass heat inserts or aluminum stand:
  Stand on MakerWorld
• 🏅 Made in Germany

Cooling:

Equipped with the AXP90-X53 Full Copper cooler for even chip cooling. All cooling components are pre-assembled. No additional rear fans or copper heatsinks included.

Technical Data:

• ASICs: 4× BM1370 (S21 Pro / Plus)
• Hashrate: 4.9 TH/s (standard operation)
• Power Consumption: approx. 75 W
• Controller: ESP32 S3 with color LCD (T-Display-S3)
• Interfaces: USB-C (Debug), WiFi, GPIO
• Power Supply: 120 W (12 V / 10 A, EU plug)

Scope of Delivery:

• NerdQaxe++ (pre-assembled)
• Thermalright AXP90-X53 Full Copper cooler
• PLA stand with brass heat inserts or aluminum stand (depending on selection)
• 120 W power supply (12 V / 10 A)
• All required screws for assembly

Note:

Performance and efficiency depend on firmware and environmental conditions. The device is designed for standard operation – overclocking is not supported. Modifications to firmware or voltage are at your own risk. No liability for damage caused by modifications.